PVC Pipe Threading Machine

JK762BP

PVC Pipe Threading Machine

PVC Pipe Threading Machine

The JK762BP has a threading capability from 250mm-600mm (min 250mm – max 700mm OD) PVC pipe plain end and bell end.

JK762BP Details:

Machine will thread both male (external) and female (internal) threads on plain end and bell end pipe.


• 1-1/2” (38.1mm) linear rails and bearings are used for X and Y table movements.


• Thread cutting motor is 5 hp 3 phase powered by a frequency drive. Part off and oring cutting motor is 3 hp 3 phase.

Model JK762BP is equipped with a 762mm (30”) ID hollow spindle which is rotated by a 1hp gear motor powered by an AC frequency drive. This design incorporates touch screen programming for all dimensions and movements. The automated movements are performed by hybrid stepper actuators and is controlled by a sophisticated PLC which has the capability to store 10 different thread dimension programs (5 pin and 5 box). The programmable touch screen also has a memory area for 6mm, 12mm and 2 TPI thread ratios. The thread cutting motor is a 5 hp 3500 rpm powered by an AC frequency drive. An additional 3 hp motor is used for cutting the part off to square end of pipe and cut oring groove when needed.

Capabilities

Automatic Pipe Threading Machine
Pipe Threading Machine
PVC Pipe Threading Machine

Dependable and Efficient

• Machine is equipped with a 762 mm ID (30”) hollow spindle. The hollow spindle is fitted with two 6 jaw expandable self centering chucks for threading bell end and flush joint plain end pipe.
• The thread setup programming which includes thread ratio selection and system testing is performed with a Panasonic GT touch screen. The screen will also display the cycle time for each joint, counters, manual operation buttons to test each system, input test display, output test display, feed settings and speed setting for all stepper motor systems.

Main frame is constructed of 4” x 4” heavy wall steel tubing. For safety, the machine will be completely enclosed and covered with steel sheet metal and polycarbonate panels for viewing. When servicing the machine, the bolted panels can be easily removed. The other panels will hinge open with locks.
Vacuum chamber for cuttings will be fitted with 4” hose connection.
Two E-Stops (emergency stops) on both sides of machine
Main machine dimensions: 80” wide x 80” long x 72” high (2m x 2m x 1.83m) An additional 20’ (6m) floor space required when threading 20’ (6m) pipe.
Pipe to be threaded is supported on four heavy duty pipe support stands equipped with multidirectional wheels.

Touch Screen Programming

Automatic Pipe Threading Machine

Touch Screen

The thread setup programming which includes thread ratio selection and system testing is performed with a Panasonic GT touch screen. The screen will also display the cycle time for each joint, counters, manual operation buttons to test each system, input test display, output test display, feed settings and speed setting for all stepper motor systems. Chucks can be set on the touch screen to open and close, manually or automatically at start and thread completion. Machine can be programmed with thread ratios which meet the ASTM F480 or DIN4925 standards, such as 6mm, 12mm, 2 TPI, 4 TPI. Additional thread types can be set up. Please contact us to discuss.

Additional Tools and Machines